With the continuous development of economy and society, greening, gardens, orchards, furniture factories and construction sites will produce countless sawdust wastes every day. The renewable utilization of resources and the environmental protection machinery market are also constantly developing. The renewable utilization of sawdust resources.

The biomass pellet machine may produce a lot of granular powder during production. The sawdust sticks to the pellets, which affects the shape of the pellets and leaves customers with an impression of poor pellet quality. The viscous pellets are more difficult to remove the powder. . Today, Kingoro Xiaobian will help you analyze the reasons.

1. If the biomass pellet machine is newly purchased, it needs to be ground by wet or oil, which is a problem that many people tend to ignore. If you ignore this link, it is likely to cause the machine to be blocked as soon as it is turned on. Of course, powder will appear. Therefore, for the purchased pellet machine, you must take some sawdust that will be pressed pellets and mix it with about 10% industrial Use oil, such as normal motor oil.

2. The sawdust particles may also be that the moisture content of the sawdust is too low. The moisture content of sawdust is too low and it is difficult to extrude. Generally speaking, the ideal humidity for granulation is 15 to 20 percent. The granulation effect is good between this humidity. If the humidity of the raw material is too low, the solution is very good. Simple, just spray some water.

3. The operation is unreasonable, there are too many materials, and the machine cannot work normally. Another is that the design of the machine itself is defective, which leads to the occurrence of gaps. If there is powder due to these two reasons, the solution is to stop first. Feed the material, then turn on the machine to clean up the material.

4. The machine is aging, the speed of the main engine is slowed down, the frequency is different, and some raw materials cannot be processed, which generally appear in some old-fashioned machines.

5. The granulation system fails, which is not what we want, but it is also a frequent mechanical failure. Most of the failures are caused by unclean materials and hard objects causing damage to the pellet machine, and problems with bearings may also cause this problem.

It is also possible that the mold in the pellet machine is damaged. If the pressure roller skin is seriously worn, the granulation effect will definitely be greatly reduced. There is no good solution to this problem, and you can only buy a new pressure roller skin. In fact, the machine also needs to rest, if you use it all the time, it can not guarantee the quality, so also pay attention not to use it for too long.

The biomass pellet mill can promote the recycling efficiency of sawdust resources.