What is the reason for the unstable current beating of the biomass fuel pellet machine? In the daily production process of the pellet machine, the current is relatively stable according to normal operation and production, so why does the current fluctuate?

Based on years of production experience, Kingoro will explain in detail the 5 reasons why the current of the fuel pellet machine is unstable:

1. The gap of the ring die of the pressure roller is not adjusted properly; if the gap between the two pressure rollers and the grinding tool is one large and the other is small, one of the pressure rollers will be difficult, and the other will be difficult, and the current will be unstable.

2. The fluctuating high and low feed rate is also the reason why the current of the pellet machine fluctuates, so the control of the feed rate must be done at a constant speed.

3. The material distribution knife is severely worn and the material distribution is uneven; if the material distribution is not uniform, it will cause uneven feeding of the pressure roller, which will also cause the current to fluctuate.

4. The voltage is unstable. In the production of the pellet machine, everyone often pays attention to the control of the ammeter, but ignores the state of the voltmeter. In fact, when the rated voltage decreases, power = voltage × current, and the starting power is basically unchanged, so when the voltage decreases , the current must increase! Since the copper coil of the motor remains unchanged, it will burn out the motor at this time. Therefore, in this case, more attention should be paid to the operating state of the biomass fuel pellet mill.

5. After the iron block and stone block enter the pellet machine, the current will fluctuate, because when the pressure roller rotates to the position of the stone block and iron block, the extrusion force of the equipment will increase sharply, causing the current to suddenly increase. After passing this position, the current will drop. Therefore, when the current suddenly fluctuates and becomes unstable, it is necessary to squeeze the material in the equipment clean and then shut down for inspection.

Do you know the 5 reasons why the current of the biomass fuel pellet machine is unstable?