How are the biomass fuel pellets processed by the biomass pellet machine burned?

1. When using biomass fuel particles, it is necessary to dry the furnace with warm fire for 2 to 4 hours, and drain the moisture inside the furnace, so as to facilitate gasification and combustion.

2. Light a match. Since the upper furnace port is used for ignition, the top-up reverse combustion method is used for gasification combustion. Therefore, when igniting, some flammable and burning materials must be used to quickly ignite the fire.

3. Since biomass fuel particles are mainly fueled by various biomass fuel particles, biomass briquette, firewood, branches, straw, etc. can also be directly burned in the furnace.

4. Before using, put the biomass fuel particles into the furnace. When the fuel is installed about 50mm below the crater, you can put a small amount of ignition matches on it to the crater, and set aside 1 small in the middle. Put a small mass of solid hot pot fuel into the small hole to facilitate ignition to ignite the kindling match.

5. When burning, cover the ash outlet. After the match is on fire, turn on the power and start the micro-fan to supply air. At the beginning, the air volume adjustment knob can be adjusted to the maximum. If it burns normally, adjust the air volume adjustment knob to the indicator sign. In the “middle” position, the furnace begins to gasify and burn, and the firepower at this time is very strong. The firepower can be controlled by turning the adjustment knob of the speed control switch.

6. In use, it can also be controlled and adjusted through the use of natural ventilation furnaces.