We often talk about preventing problems before they happen, so how to prevent wood pellet machine equipment failures early?

1. The wood pellet unit should be used in a dry room, and cannot be used in places where there are corrosive gases such as acids in the atmosphere.

2. Regularly check the parts to see if the work is normal, and carry out an inspection once a month. The inspection content includes whether the worm gear, worm, bolts on the lubricating block, bearings and other moving parts are flexible and worn. If defects are found, they should be repaired in time. continue to use.
3. After the wood pellet machine equipment group is used or stopped, the rotating drum should be taken out for cleaning and cleaning of the remaining powder in the bucket (only for certain pellet machines), and then installed to prepare for the next use.

4. When the drum moves back and forth during work, the M10 screw on the front bearing should be adjusted to the proper position. If the gear shaft moves, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make noise, turn the pulley by hand, and the tightness is appropriate. If it is too tight or too loose, the machine may be damaged.

5. If the suspension time is too long, the whole body of the sawdust pellet machine equipment must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth awning.

As long as the above work is done, the failure of wood pellet machine equipment can be greatly reduced, so that the efficiency of wood pellet machine equipment can reach the highest level.