When there is a problem with our biomass fuel pellet machine, what should we do? This is a problem that our customers are very concerned about, because if we don’t pay attention, a small part may destroy our equipment. Therefore, we must pay attention to the maintenance and repair of the equipment, so that our pellet machine can be normal or even overloaded without problems. The following Kingoro editor will introduce some issues that need to be paid attention to when disassembling and assembling the fuel pellet machine:

1. Under normal circumstances, it is not necessary to dismantle the feed cover, but only need to open the observation window on the granulation chamber to check the working condition of the pressing wheel.

2. If you need to replace the pressure roller or replace the mold, you need to remove the feed cover and the pressure roller bin, unscrew the screws and nuts above, and then unscrew the locking nut on the main shaft, and use the lifting belt for the pressure roller assembly. Lift it up and move it out of the pressure wheel compartment, then screw it into the process hole on the die plate with two hoisting screws, hoist it with a hoisting belt, and then use the other side of the die in reverse.

3. If the pressure roller skin or the pressure roller bearing needs to be replaced, it is necessary to remove the outer sealing cover on the pressure roller, remove the round nut on the pressure roller shaft, and then drive out the pressure roller bearing from the inside to the outside, and remove the bearing. If it needs to be replaced or not (cleaned with diesel oil), the inner hole of the pressure roller should be kept clean, and then the pressure roller assembly can be installed in reverse order.

Biomass fuel pellet machines are now more and more widely used because of their unique characteristics. When using pellet machines, it is necessary to prevent some common problems from appearing, so as to make pellet machines work more efficiently and prolong their service life.

The following problems should be paid attention to when using the biomass fuel pellet machine:

1. Do not add too many raw materials in the initial operation stage of the pellet machine. During the running-in period, the output of the new machine is generally lower than the rated output, but after the running-in period, the output will reach the rated output of the machine itself.

2. Special attention should be paid to the analysis of the grinding of the pellet machine. The pellet machine needs to be run-in after it is purchased. Before it is officially used, reasonable grinding has a very important influence on the later use of the pellet machine. The ring molding of the fuel pellet machine The roller is a heat-treated part. During the heat-treatment process, there are some burrs in the inner hole of the ring die. These burrs will hinder the flow and forming of the material during the operation of the pellet mill. It is strictly forbidden to add hard sundries into the feeding device, so as not to damage the mold and affect the production efficiency and life of the pellet machine.

3. In terms of the smoothing and cooling process of the biomass pellet machine, the pressing roller of the pellet machine should squeeze the wood chips and other materials into the inner hole of the mold, and push the raw material on the opposite side into the front raw material. The pressing roller of the pellet machine directly affects the Forming of particles.

Finally, in order to ensure the safety of production, fatigue operation of the machine is strictly prohibited.