Recently, due to the continuous research and development of new products of wood pellet machine manufacturers, natural wood pellet machines are also sold quite a lot.

It is not so unfamiliar to some factories and farms, but the operation of the wood pellet machine is better than simple. It may also be difficult for some factories and farms that have not used wood pellet machines. But don’t worry. Even if you haven’t touched it, it doesn’t matter if you haven’t used it. Now the wood pellet machine manufacturers are a complete set of services. Having said so much, how to operate the wood pellet machine? Let’s explain the correct operation process of the wood pellet machine in detail.

After getting the sawdust pellet machine from the factory or farm, don’t rush into production, first let the technicians of the sawdust pellet machine manufacturer check whether the layout or line is standardized. Then we do the following:

1. Check before starting

Before starting the machine, first check the running direction of the sawdust pellet machine, whether it is consistent with the running direction of the pellet machine machine.
2. Running-in of sawdust pellet machine mold

After the wood pellet machine is obtained, it is not necessary to produce it directly, because the new machine needs to be run-in, which can make the produced fuel more shiny. You can mix some oil with some raw materials, stir it evenly, add it to the sawdust pellet machine, and let the machine run-in production.

3. Control the moisture of the raw material of the wood pellet machine

The raw materials used should not be too dry and need to contain a certain amount of water. If the crude fiber content is high, it is better. Add some oily raw materials (such as soybean meal, soybean, tea cake, etc.). It is better to process the fuel. Add 3% water to mix, which has no effect on the processed fuel. Because the processed fuel is heated, it can emit water.

4. Adjust the length of the pellets of the sawdust pellet machine

If it is necessary to adjust the length of the fuel particles, the chipper blade at the discharge port can be adjusted up and down, and the staff can adjust the length according to the actual needs.
5. Feeding steps of sawdust pellet machine

When the staff uses the wood pellet machine to add raw materials, they must remember that they cannot put their hands into the feeding port. For example, sometimes the raw materials are difficult to go down, and auxiliary wooden sticks can be used for feeding.

6. Add oil to wood pellet machine

The pellet machine of the wood pellet machine manufacturer generally needs to add high temperature resistant grease to the pressure wheel bearing when the pressure wheel is processed to about several thousand kilograms. The quality of the lubricating oil with high temperature has a great influence on the lubricity of the bearing during the production process. It is better to carry out comprehensive maintenance every six months, and add high-temperature grease to the main shaft and bearings.

7. Sawdust pellet machine

If you want to replace the grinding disc, pressing wheel and other accessories, for the sake of insurance, you must first cut off the power supply and turn off the main switch of the sawdust pellet machine before you can touch the pressing wheel and grinding disc with your hands and other tools.

I believe that you have never seen such a detailed introduction to the wood pellet machine of the wood pellet machine manufacturer. Through the above series of operation procedures, we have basically understood the correct operation process of the wood pellet machine, and how important it is to standardize the use of the wood pellet machine, which will help prolong the life of the wood pellet machine.