Usually, when we use the wood pellet machine, the lubrication system inside the equipment is an indispensable part of the entire production line. If there is a lack of lubricating oil during the operation of the wood pellet machine, the wood pellet machine cannot operate normally. Because when the wood pellet machine is in operation, the pressure is very huge, because when making pellets, the friction between the raw materials will generate a lot of heat, which will lead to high temperature and deformation of the equipment. When producing pellets, what are the requirements for emergency bearing lubrication of wood pellet machines:

Generally speaking, the raw materials used in the wood pellet machine produced by our factory are eucalyptus, birch, poplar, fruit wood, sawdust, branches, etc. as the raw materials for making pellets. At the same time, the wood pellet machine can effectively solve the problem. The raw material of crude fiber is difficult to granulate and other problems, we can customize high-quality molds for various granulators so that the life of the equipment can be extended, and the quality of granules can also be improved and the excessive consumption of raw materials can be reduced.

In this regard, we must pay attention to learning what the emergency bearing lubrication requirements of the wood pellet machine are during the production and operation of the wood pellet machine:
1. When the wood pellet machine runs continuously for 4 hours, it is necessary to lubricate the pressing roller of the equipment at least once. It is also recommended to give a small amount of lubrication every 1 hour of operation (grease the rolls at the end of each process – to keep material from getting in. The butter in the rolls shrinks as it cools, eventually pulling material into the bearings).

2. Lubricate the spindle bearing of the sawdust pellet machine every 8 hours.

3. When the wood pellet machine works for 2000 hours, or every 6 months, the gearbox oil should be changed.

4. Check the oil level of the feeder drive on time every week, and add a little oil to the roller chain drive.

5. Lubricate the conditioner of the wood pellet machine and the bearing of the feeder shaft once a month.

6. The last thing to pay attention to is to lubricate the cutter frame of the sawdust pellet machine once a day, and it is recommended to lubricate it manually in order to make the operation more convenient.

The above is the summary of our company about the details of the emergency bearing lubrication requirements of the sawdust pellet machine during the pelletizing operation of the sawdust pellet machine. In order to avoid the failure of the wood pellet machine during the pelletizing operation and thus affect the output, it is necessary to carry out maintenance work on the wood pellet machine at regular intervals.