The biomass granulator can only meet the output demand under the state of normal production. Therefore, every aspect of it needs to be carried out carefully. If the pellet machine is well maintained, it can operate normally.

In this article, the editor will talk about what management can be done to ensure the stable operation of the equipment?

1: For the management of the feeding port, different biomass materials should be stored in independent warehouses and special places to prevent (flammable and explosive materials, open flames), and mark the name of the raw material, Ambient humidity and purchase time.

The warehouse keeper of the pellet machine production line should unify the serial number of the pellet machine feed port, and after drawing a detailed map of the regional distribution of each material yard, notify the laboratory, the operator, the machine equipment supervisor and the feeder respectively, and cooperate with the staff to communicate with each other. Clear the incoming slogan and the storage status of each raw material.

2: The management method of lifting materials, smoke, etc., each feed port should be marked with the name of the raw material stored by the pellet machine and the ambient humidity; each feed port of the pellet machine should be marked with the same logo as the cooler and vibrating screen, Mark the specification model and serial number, etc. Each particle production line should be managed by full-time personnel.

When biomass fuel materials are put into the warehouse, both the material receiving staff and the supplier personnel should check and sign for confirmation, so as to avoid errors in the feeding process, resulting in damage to production and manufacturing.

The warehouse keeper of the pellet machine production line solves the problem of unifying the serial number of the raw material feeding port, making the distribution of the feeding port, and respectively notifying the laboratory and control system supervisor.

3: Regularly maintain whether the parts are working normally, and check once a month. The inspection contents include whether the moving parts such as worm gear, worm, anchor bolts and bearings on the lubricating block are normal.

Easy to turn and damage. If any defects are found, they should be repaired immediately and should not be used.

4: After the granulator is applied or terminated, the rotating drum should be removed to clean and remove the powder remaining in the barrel (only for some powder granulator units), and then properly installed to prepare for the next application in advance.

5: When the drum moves back and forth during the operation process, the M10 screw on the front bearing pawl should be adjusted to a moderate position. If the shaft sleeve moves, please adjust the M10 screw on the back of the bearing frame to an appropriate position, adjust the gap, so that the bearing does not emit noise, and rotate the belt pulley forcefully, and the tightness is moderate. If it is too tight or too loose, the device may be damaged.

6: If the equipment is terminated for a long time, the whole body particle unit must be cleaned and cleaned, and the smooth surface of the equipment parts must be coated with anti-rust agent and covered with a cloth.