Even if customers buy biomass fuel pellet machines to make money, if the molding is not good, they will not make money, so why is the pellet molding not good? This problem has troubled many people in biomass pellet factories. The following editor will explain from the types of raw materials. Next, let’s learn about it together!

Various types of raw materials have different compression molding properties. The type of material not only affects the molding quality, such as the density, strength, calorific value of wood pellets, etc., but also affects the output and power consumption of the biomass fuel pellet machine.

Among many agricultural and forestry wastes, some crushed plants are easily crushed into pellets, while others are more difficult. The wood chips themselves contain a large amount of lignin, which can be bonded at a high temperature of 80 degrees, so the molding of the wood chips does not require the addition of adhesives.

The particle size of the material is also an important factor affecting the molding. For a certain molding method, the particle size of the material cannot be larger than a certain particle size.

Biomass fuel granulator is a kind of equipment used to develop wet powder into desired granules, and can also pulverize block dry materials into desired granules. The main feature is that the screen is easy to assemble and disassemble, and the tightness can be adjusted appropriately, which is convenient to disassemble and easy to clean.
So the biomass fuel pellet machine as a machine and equipment should pay more attention to the usual maintenance and maintenance. How should the pellet machine be maintained? Let me introduce to you below.

1. Regularly check the parts.

Once a month, check the worm gear, worm, bolts on the lubricating block, bearings and other moving parts for flexible rotation and wear. If defects are found, they should be repaired in time, and should not be used reluctantly.

2. After the biomass fuel pellet machine is used or stopped, the rotating drum should be taken out for cleaning and the remaining powder in the bucket should be cleaned, and then installed to prepare for the next use.

3. When the drum moves back and forth during work, please adjust the M10 screw on the front bearing to the proper position. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make noise, turn the pulley by hand, and the tightness is appropriate. Too tight or too loose can cause damage to the machine. .

4. The biomass fuel pellet machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.

5. If the stoppage time is long, the whole body of the biomass fuel pellet machine must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth awning.